Skip to main content
Article

Thermodynamic assessment of a cogeneration system with CSP Driven-Brayton and Rankine cycles for electric power and hydrogen production in the framework of the energy and water nexus

Ehsanolah AssarehDepartment of Mechanical Engineering, Dezful Branch, Islamic Azad University, Dezful, IranMohammad AssarehMechanical Engineering Department, Jundi-Shapur University of Technology, Dezful, IranSeyed Mojtaba AlirahmiDepartment of Mechanical Engineering, Dezful Branch, Islamic Azad University, Dezful, IranMilad ShayeghMechanical Engineering Department, Jundi-Shapur University of Technology, Dezful, IranFuqiang WangSchool of New Energy, Harbin Institute of Technology at Weihai, 2, West Wenhua Road, Weihai 264209, ChinaMohammadali BehrangDepartment of Mechanical Engineering, Dezful Branch, Islamic Azad University, Dezful, IranXiaolin WangSchool of Engineering, University of Tasmania, Hobart, TAS 7001, Australia
2021en
ABI

Abstract

In increasingly energy-dependent world, there is a question mark over the viability of fossil fuel resources. To tackle this issue, an integrated poly-generation system based on concentrated solar power is proposed to feed in the city grid and produce hydrogen as a clean energy carrier. Concerning the COVID-19 outbreak, all countries are in dire need of oxygen. Therefore, the produced oxygen in this system can be considered as an added value. The introduced scheme applies solar energy to supply thermal energy to a Brayton cycle. Two bottoming Rankine cycles are employed to empower a PEM electrolyzer using the residual heat from the gas turbine. The system is modelled using the Engineering Equations Solver for a comprehensive thermo-economic analysis. The exergy destruction analysis proved a significant loss of exergy by the solar field, illustrating the necessity to address this in future research. Afterwards, six design variables were selected and then optimized for the proposed system using the NSGA-II. Based on the TOPSIS approach, exergy efficiency, and capital cost rate, the objective functions were 22.2% and 272.6 $/h, respectively. Finally, a case study was performed to investigate the impact of solar irradiation and ambient temperature on system outputs.

Identifiers

Citations and references

Cited by 20 references