Статья

THE RESEARCH OF MICRO-HARDNESS OF SIDE SURFACES OF TEETH CYLINDRICAL WHEELS PROCESSED BY “SHAVER-ROLLING DEVICE”

Карибек ШеровKaraganda State Technical University, 100027, B. Mira str. 56, Karaganda, KazakhstanB. T. MardonovNawaii State Mining Institute, 210100, st. Galaba shokh 170, Navoi city, UzbekistanToty BuzauovaKaraganda State Technical University, 100027, B. Mira str. 56, Karaganda, KazakhstanSayagul TussupovaKaraganda State Technical University, 100027, B. Mira str. 56, Karaganda, KazakhstanNurgul SmakovaKaraganda State Technical University, 100027, B. Mira str. 56, Karaganda, KazakhstanAigerim IzotovaKaraganda State Technical University, 100027, B. Mira str. 56, Karaganda, KazakhstanRiza GabdyssalikD. Serikbaev East Kazakhstan State Technical University, 070004, St. Protozanova A.K., 69, Ust-Kamenogorsk, KazakhstanT. B. KURMANGALIYEVD. Serikbaev East Kazakhstan State Technical University, 070004, St. Protozanova A.K., 69, Ust-Kamenogorsk, KazakhstanD. E. ELEMESD. Serikbaev East Kazakhstan State Technical University, 070004, St. Protozanova A.K., 69, Ust-Kamenogorsk, Kazakhstan

Journal of theoretical and applied mechanicsjournal2020en

ABI

Аннотация

This article presents the results of the study of micro-hardness on the end surface along the involute tooth profile after processing with a rolling tool. The results of the study showed that the value of micro hardness obtained by processing with "shaver-rolling device" made of steel R6M5 is obtained within HB 263-271, and when processed with using "shaver-rolling device" made of ShH15 steel within HB 274-276. The results of experimental studies have shown that with an increase in cutting speed, the micro-hardness of the side and main working surfaces of the teeth wheel decreases. The most favorable results were obtained when processing tools is made of steel ShH15 at cutting conditions: n = 100-400 rpm; S = 0.2 mm/rotation.

Перевод пока недоступен

Темы

Engineering Technology and Methodologies Metallurgy and Material Forming Engineering Diagnostics and Reliability

Идентификаторы

DOI: 10.7546/jtam.50.20.01.05

Цитирования и источники

Цитирований: 1 Использованных источников: 1

Показатели — AkademScholar · Скоро