Manufacturing of balanced inter-saw spacers
D. M. MukhammadievInstitute of Mechanics and Seismic Stability of Structures named after M.T. Urazbaev, Academy of Sciences of the Republic of Uzbekistan, Tashkent, 100125, UzbekistanFarhod IbragimovInstitute of Mechanics and Seismic Stability of Structures named after M.T. Urazbaev, Academy of Sciences of the Republic of Uzbekistan, Tashkent, 100125, UzbekistanOrtiq AbzoirovInstitute of Mechanics and Seismic Stability of Structures named after M.T. Urazbaev, Academy of Sciences of the Republic of Uzbekistan, Tashkent, 100125, UzbekistanNizomiddin JumaevInstitute of Mechanics and Seismic Stability of Structures named after M.T. Urazbaev, Academy of Sciences of the Republic of Uzbekistan, Tashkent, 100125, UzbekistanLola ZhamolovaTashkent State Agrarian University, Tashkent, 100140, Uzbekistan
ABI
Аннотация
The article defibes the ways to manufacture statically balanced inter-saw spacers for fiber-cleaning and linting machines. In manufacturing steel spacers, a welded belt joint is used where the weld seam causes an imbalance of spacers. To achieve static balance in the inter-saw spacers, we create two holes of 13.2 mm diameter in single-belt spacers and 11.85 mm diameter in two-belt spacers. At that, the remaining 10 holes in both types of spacers are made with a diameter of 15 mm, which makes it possible to balance the imbalance of these inter-saw spacers. In addition, the single-belt spacer is recommended for shafts of saw blades with large diameters, and two-belt spacers - for shafts with smaller diameters.
Темы
Идентификаторы
Цитирования и источники
Цитирований: 0Использованных источников: 3
Показатели — AkademScholar · Скоро