Improvement of continuous forming the “Conform” method
A R FastikovskiySiberian State Industrial University, 42 Kirova street, Novokuznetsk, 654007, RussiaE. V. SelivanovaSiberian State Industrial University, 42 Kirova street, Novokuznetsk, 654007, RussiaА. А. ФедоровSiberian State Industrial University, 42 Kirova street, Novokuznetsk, 654007, RussiaV. N. Peretyat’koSiberian State Industrial University, 42 Kirova street, Novokuznetsk, 654007, RussiaВ. В. ЕвстифеевSiberian State Automobile and Highway University, 5 Prospekt Mira, Omsk, 64080, RussiaO Yu Efimov
2018en
ABI
Аннотация
Improvements of continuous forming method "Conform" are offered, consisting in the possibility of changing the slope angle of the bearing plate relative to the wheel, allowing a number of restrictions to be removed, the setup and operation of the equipment to be substantially simplified. Conditions are determined according to which the workpiece capture and the mounting of the bearing plate at various angles are possible. The reliability of the dependences obtained is confirmed by the studies carried out on the laboratory installation.
Перевод пока недоступен
Идентификаторы
Цитирования и источники
Цитирований: 3Использованных источников: 0