Статья

Experimental study on transverse displacement of the metal during cold thin strip rolling

Zhongkai RenNational Engineering Research Center for Equipment and Technology of Cold Strip Rolling, Yanshan University, Qinhuangdao 066004, Hebei, ChinaHong XiaoNational Engineering Research Center for Equipment and Technology of Cold Strip Rolling, Yanshan University, Qinhuangdao 066004, Hebei, ChinaChao YuCollege of Mechanical Engineering, Yanshan University, Qinhuangdao 066004, Hebei, ChinaJian WangNational Engineering Research Center for Equipment and Technology of Cold Strip Rolling, Yanshan University, Qinhuangdao 066004, Hebei, China

2017en

ABI

Аннотация

The theory of metal plastic deformation is an important part of the strip shape control theories. In order to control the shape and gauge accurately during cold thin strip rolling, the mechanism of the lateral flow of the metal must be revealed clearly. In this research, the transverse displacement of thin strip was studied by the grid method. Grids with line thickness of 10 μm and clear boundary were successfully manufactured on the surface of 304-stainless steels using lithography technology. Then, the effects of reduction, front and back tension, and taper angle of the first intermediate roll on the lateral flow of the metal were studied. The calculations of strip shape were compared with the measured results. It is shown that the effect of the transverse displacement on the strip shape can't be neglected.

Перевод пока недоступен

Идентификаторы

DOI: 10.1016/j.proeng.2017.10.891

Цитирования и источники

Цитирований: 2Использованных источников: 0

Показатели — AkademScholar