Analysis of fibrous material deformation in the roll contact zone
Shavkat KhurramovTashkent University of Architecture and Civil Engineering, Yangi shahar street, 9, Tashkent city, 100194, UzbekistanAkbar AbrorovBukhara Institute of Engineering and Technology, Murtazaev street, 15, Bukhara, UzbekistanA. R. AbdullaevTashkent University of Architecture and Civil Engineering, Yangi shahar street, 9, Tashkent city, 100194, UzbekistanNusiratjon NorovTashkent University of Architecture and Civil Engineering, Yangi shahar street, 9, Tashkent city, 100194, UzbekistanShakhriddin BaymatovTashkent University of Architecture and Civil Engineering, Yangi shahar street, 9, Tashkent city, 100194, Uzbekistan
ABI
Аннотация
The analytical description of the shape of contact curves and the thickness of processed material in the technological zone of a two-roll module in a dynamic mode is given, considering the deformation pattern of the processed material. It is determined that one of the factors that most influence the shape of the contact curve is the ratio of the compression rate of the coating deformation to the corresponding material feed rate. It is established that the minimum thickness of the material processed in a two- roll module depends on the initial thickness of the processed material, the gap between the rolls, and the ratio of the compression rate of the coating deformation to the corresponding material rate.
Ҳали таржима қилинмаган
Мавзулар
Идентификаторлар
Иқтибослар ва манбалар
0 та иқтибос6 та фойдаланилган манба