Asosiy kontentga oʻtish
Boshqa

Process Time Optimization of a Hot Stamping Line for Aluminum Automotive Components

Unai IbarretxeMondragon Unibertsitatea, Loramendi, 4, 20500 Arrasate – MondragonSara GarmendiaMondragon Unibertsitatea, Loramendi, 4, 20500 Arrasate – MondragonNagore OtegiMondragon Unibertsitatea, Loramendi, 4, 20500 Arrasate – MondragonUnai ArgarateKoniker S. Coop., San Andres Auzoa 20, 20500 Arrasate – MondragonAndoitz AranburuFagor Arrasate S. Coop., San Andres Auzoa 20, 20500 Arrasate – MondragonAitor OrmaetxeaFagor Arrasate S. Coop., San Andres Auzoa 20, 20500 Arrasate – MondragonMonica CarranzaBatz S. Coop., Torrea Auzoa 2, 48140 IgorreLander GaldosMondragon Unibertsitatea, Loramendi, 4, 20500 Arrasate – Mondragon
2024en
Ochiq kirishGibrid

Litsenziya: cc-by

ABI

Annotatsiya

Abstract Implementing lightweight solutions is crucial for reducing overall car weight, with 7xxx and 6xxx aluminum series offering competitive strength-to-weight ratios. Increasing fuel costs and stricter environmental regulations are driving demand for eco-friendly vehicles, prompting automotive manufacturers to seek innovative lightweight solutions. Hot stamped aluminum alloys are gaining prominence due to their specific strength and improved formability compared to cold formed components. However, there is a lack of depth in knowledge for establishing reliable and optimized aluminum hot forming processes To address this, Mondragon Unibertsitatea, Fagor Arrasate, and Batz have initiated collaborative trials involving hot stamping of authentic automobile bumpers using highstrength 6xxx and 7xxx aluminum alloys. The trials under different process times have been empirically tested using the mechanical properties of stamped bumpers, by defining optimal furnace, transfer, and quenching times. Simulations using FEM have been conducted to determine real process times for continuous hot stamping lines equipped with cooling channels. Thermophysical and rheological characterization of aluminum, followed by the development of predictive models for mechanical properties, have been integrated into the simulation framework. Results show that extremely short furnace and quenching times, as brief as 1 second, can be employed while maintaining acceptable mechanical properties in a rapid cycle hot stamping process. These expedited process times have the potential to increase production by up to 75% compared to conventional press hardening processes for the equivalent steel bumpers.

Hali tarjima qilinmagan

Identifikatorlar

Iqtiboslar va manbalar