Asosiy kontentga oʻtish
Maqola

Theoretical Determination of Changes in Chain Networks Lengths

Akbarov OgliFerghana Polytechnical InstituteXusanov YuldashalievichDepartment of Applied Mechanics, Fergana State Technical University, Fergana, Uzbekistan
2026en
ABI

Annotatsiya

This article presents the results of a study on improving surface quality during the mechanical machining of complex-shaped sections of metal mold components manufactured for the production of plastic products by injection molding. In the conventional milling method, narrow guide grooves (2.9 mm in width, 2.0 mm in depth) require machining with small-diameter end mills (D=2.5 mm). Such cutters have low stiffness, are prone to vibration, wear quickly, and degrade the surface quality. The study proposes a technology in which the difficult-to-machine section is manufactured as a separate part and installed into a seat formed in the main mold component by means of an interference fit. This approach eliminates the need for special fixtures and enables the use of larger-diameter (D=12 mm) rigid end mills. Experimental investigations were conducted on 40X structural alloy steel, comparing conventional milling with the proposed separate part technology. A power-regression mathematical model relating surface roughness to the main cutting parameters (cutting speed and feed per tooth) was developed and validated against experimental data. The results showed that surface roughness improved by 45.8% (from Ra=1.42 to Ra=0.77 μm), machining time decreased by 18.4%, and tool stiffness increased by a factor of 179. The proposed technology was implemented at the Navoi Machine-Building Plant, confirming its practical effectiveness.

Hali tarjima qilinmagan

Identifikatorlar

Iqtiboslar va manbalar