Asosiy kontentga oʻtish
Maqola

N,S-Donor Triazole–Thione-Modified Graphite Paste Electrode for Selective Voltammetric Detection of Cu(II) in Environmental Waters

Nigora QutlimurotovaDepartment of Analytical Chemistry, National University of Uzbekistan, Tashkent 100174, UzbekistanDilsora AxmadovaDepartment of Analytical Chemistry, National University of Uzbekistan, Tashkent 100174, UzbekistanDilnoza IsmailovaS. Yu. Yunusov Institute of the Chemistry of Plant Substances Uzbekistan Academy of Sciences, Tashkent 100170, UzbekistanJasur TursunqulovDepartment of Pharmaceuticals and Chemistry, Faculty of Medicine, Alfraganus University, Tashkent 100190, UzbekistanRukhiya QutlimurotovaWestminster International University in TashkentLola YusupovaTashkent Chemical-Technological InstituteSholpan YespenbetovaFaculty of Natural Sciences, Korkyt Ata Kyzylorda University, Kyzylorda 120014, KazakhstanNargiza AtakulovaAlmaliq Mining and Metallurgical Combine, Almalyk 110100, Tashkent Region, Uzbekistan
2026en
ABI

Annotatsiya

A simple and cost-effective graphite paste electrode modified with 5-(4-aminophenyl)-4-amino-1,2,4-triazole-3(2H)-thione was developed for the selective voltammetric determination of Cu(II) ions in environmental water samples. The N,S-donor ligand was incorporated into a graphite–polystyrene matrix without the use of nanomaterials, providing a reproducible and straightforward electrode fabrication route. Scanning electron microscopy revealed a rough, porous surface morphology with an enhanced electroactive surface area of 0.065 cm2, approximately twice the geometric area. Electrochemical impedance spectroscopy confirmed diffusion-controlled mass transport, while cyclic voltammetry indicated quasi-reversible behaviour of the Cu(II)/Cu(0) redox system with a linear dependence of peak current on the square root of the scan rate. Differential pulse voltammetry under optimised conditions (0.1 mol·L−1 H2SO4, pH 1.0–1.2) yielded a linear analytical response over the concentration range of 0.01–0.4 μmol·L−1 (R2 = 0.99507), with a limit of detection of 0.02 μmol·L−1 and a limit of quantification of 0.06 μmol·L−1—well below the WHO guideline for copper in drinking water. The sensing mechanism involves selective N,S-bidentate coordination of Cu(II) at the electrode surface, followed by electrochemical reduction, as supported by FT-IR spectroscopic evidence. The sensor demonstrated good selectivity toward Cu(II) in the presence of common interfering metal ions at up to 20-fold excess. The method was successfully validated against ICP-OES (recovery 99.8%, RSD < 0.33%) and confirmed by spike–recovery experiments (99.0–99.5%), confirming its practical applicability for trace-level environmental monitoring. The modified electrode retained approximately 93% of its initial response after 30 consecutive measurements and 91% after 14 days of storage, demonstrating good operational stability.

Hali tarjima qilinmagan

Identifikatorlar

Iqtiboslar va manbalar

0 ta iqtibos0 ta foydalanilgan manba