Asosiy kontentga oʻtish
Maqola

Linking Traffic Microsimulation to a Power-Based Vehicle Model to Assess How Operating Regimes Affect Fuel Use and Brake Wear of Diesel, CNG and Electric City Buses

Ulugbek XabibulayevichDepartment of Road Traffic Safety, Namangan State Technical University, Namangan, Uzbekistan
2026en
Ochiq kirishOlmos

Litsenziya: cc-by

ABI

Annotatsiya

Traffic engineers routinely use microsimulation to compare bus priority measures, but they report the results almost exclusively as travel time and delay. What happens to the bus itself — its fuel or energy use, the work done by its brakes, the load on its powertrain — is rarely calculated, although these quantities decide the operator's costs. This study closes part of that gap. Driving cycles of a typical Namangan bus corridor (10.4 km, 25 stops, 12 signalised junctions) were generated from PTV Vissim outputs for five operating regimes: the current schedule-based service, an optimised timetable, a shorter headway, conditional transit signal priority (TSP) and an integrated regime. The cycles were fed into a power-based longitudinal model of three 12-m buses: diesel, compressed natural gas (CNG) and battery-electric. The model accounts for passenger load, auxiliary power and, for the electric bus, regenerative braking. In the current regime the diesel bus used 39.3 L/100 km; 35% of the time was spent standing, and 46% of the positive traction energy was later dissipated in the brakes. A decomposition showed that 44.5% of the fuel was time-related (idling and auxiliaries) and 32.6% was spent during acceleration, which occupied only one-tenth of the time. The integrated regime raised the operating speed from 14.3 to 17.1 km/h and reduced consumption by 13.5% for the diesel bus, 13.4% for the CNG bus and 11.7% for the electric bus; TSP alone gave 8.3–9.6%. Brake energy fell by 18%, which corresponds to an estimated 22% longer pad life. A regression fitted to 260 simulated cycles, Q = 10.20 + 0.0601τ + 0.0601 n_st v_c 2 + 8.05γ (R 2 = 0.894), reproduces fuel use from three route descriptors with a mean error of 2.2%, and its coefficients agree with their physical estimates within 2–10%. When off-peak hours are included the daily saving of the integrated regime falls to about 10%. The results show that bus priority measures should be appraised by their effect on the number of stops per kilometre, not only by travel time, and that fuel norms for city buses could be made route-specific with little extra data.

Hali tarjima qilinmagan

Identifikatorlar

Iqtiboslar va manbalar