Asosiy kontentga oʻtish
Maqola

A Study of the Fibre-transfer-channel Design in Rotor-spinning. Part I: The Fibre Trajectory

C. A. LawrenceDepartment of Textiles, University of Manchester Institute of Science and Technology, Manchester 1, EnglandK. Z. ChenDepartment of Textiles, University of Manchester Institute of Science and Technology, Manchester 1, England
1988en
ABI

Annotatsiya

An investigation is described in which high-speed cinematography was used to study the removal of fibres from the opening roller and their passage through the transfer channel during rotor-spinning. From the results obtained, it was concluded that short fibres would escape the pin-clothing of the opening roller in the region of the trash box. These fibres pass over the knife edge of the transfer-channel interface and are then drawn back into the mass of flow down the channel. Longer fibres will remain with their leading ends hooked around the pin-clothing, while their trailing lengths are ejected from the opening roller and bend over the knife-edge before the fibres are pulled down into the channel. An analysis of the transfer-channel design showed that a narrow rectangular cross-section, as opposed to a circular one, was more conducive to fibre-straightening.

Hali tarjima qilinmagan

Identifikatorlar

Iqtiboslar va manbalar

5 ta iqtibos0 ta foydalanilgan manba