Power supply for a CIP position for bearings

Objective: Two possible options for power sources are considered: a controlled three-phase bridge rectifi er circuit with a step-down transformer and a pulse converter receiving power from the network through an uncontrolled three-phase bridge rectifi er to drive the wheel-motor units of electric locomotives and electric trains into rotation with the required frequency at the position of CIP bearing diagnostics. In both cases, it is assumed that the power supplies receive electricity from the 380/220 V, 50 Hz network. The power source is loaded with traction motors of the ER2R, ER2T, ET2, ET2M electric trains and the VL-10 electric locomotive. Methods: Mathematical modeling is used in the MatLab/Simulink environment for analytical calculations. Results: The currents and voltages of the load were determined, based on the calculations, the control angles and power factors of the rectifi er with a step-down transformer, the duty cycle of the pulse converter. Practical importance: A variant of an energy-effi cient power supply is proposed, including an uncontrolled rectifi er and a pulse converter.

Hali tarjima qilinmagan